How-To

Julianos Lift Latch Retractable Lap Belts For Tri-Five Chevy’s – Interior by Vinny’s Interiors

At Julianos Hot Rods we sell seat belts to trim shops across the country. One of the best is Vinny's Interiors in New Britain, PA. You can tell by the quality of the seat upholstery, carpet fit and door panels that his work is top of the line. Vi … [Read more...]

SEAT BELTS FOR OLD HOT RODS Story & Photos By Jim Clark (The Hot Rod MD)

I came across this article online of a seatbelt install by Jim Clark in a 32 Ford roadster. Jim explains how he went about putting the belts into his hotrod and it looked awesome when he was finished. A clean tidy and safe installation … [Read more...]

Buick Street Rod makes a Comeback with Some Serious Power Under the Hood

I have to share this car with my blog followers! It really is a beautiful car with amazing engineering and wicked performance. A good buddy of mine decided to make a big change in his Buick with an LS3 out of a Camaro SS. The independent front and W … [Read more...]

Juliano’s 2 Point Retractable Lap Belts for an International Scout with Bucket Seats

Here's a few photos of Toby and I mocking up retractable lap belts in a hot rod scout. Every so often we get to work with local customers in the Connecticut area and our buddy Mike was in need of some safety belts. Our 13 inch retractor see … [Read more...]

INSTALLING 9 INCH SEAL BEAM IN 32 FORD

REMOVE ORIGINAL LENS AND RING. CLIP SEAL BEAM INTO TRIM RING USING NEW WIRE CLIPS SUPPLIED WITH BULBS PLUG WIRES INTO EXISTING BULB SOCKET AND SNAP TRIM RING AND BULB TO BUCKET THE FINISHED LOOK … [Read more...]

INSTALLING PARKING/DIRECTIONAL LIGHT 35-36 FOR HEADLIGHT

TRACE LIGHT HOUSING HOLDING THE HOUSING 1/4 FROM FRONT OF BUCKET MARK SCREW HOLE 2 1/4 INCHES BACK FROM TAB DRILL BOTH HOLES ON MARKS INSTALL RUBBER GROMET IN WIRE HOLE INSTALL LIGHT WITH SUPPLIED SCREW THIS IS THE FINISHED LOOK … [Read more...]

HOW TO INSTALL 35-36 FORD AEROBRITE

PLACE TAPE ON BUCKET FOR EASE OF MARKING MARK HOLES MAKING SURE THE TOP OF THE ADAPTOR RING IS TOP DEAD CENTER CENTER PUNCH HOLES DRILL HOLES ATTACH ADAPTOR RING WITH SUPPLIED HARDWARE. (if the bulb is loose after the trim ring is installed you … [Read more...]